The ground colour is printed from one bucket of mixed spot ink, it is not built up from four colours, and the bright green is that bright green. After the bright colour a matte film goes over the whole face, light does not bounce off it, and a hand on it feels a fine matte grain. The holes are on the two sides, a thick cotton rope goes in and is knotted on the side, and the front face has no rope end showing. The paper is thick white card, the mouth is folded over once, and the bag stands on the counter without leaning. The bag is not big, one T shirt or one small square box sits in it and a hand does not tire holding it down the street. The logo, the spot colours and the size are all changed to yours, and you give the colour number.
Spot Colour Print in a Bright Shade, It Catches the Eye
The ground colour is printed from spot ink, one bucket of ink is mixed first and then it goes on the press, it is not built up from four colours. A shade like this bright green or a fluorescent pink cannot come out of a four colour press, the colours pile up and go dull and grey, and spot ink prints the brightness as it is. The ground is even from the mouth down to the bottom, there is no patch that is deeper than the next, and there is no screen dot to be seen. The paper is thick high weight white card, the face takes ink, and the spot colour does not spread on it. The bag comes up square, the four corners are cut as right angles by the die, they are not rounded off by a fold. The folded edge is creased first and folded after, so the edge is one straight line and no loose paper sits inside it. Standing on the counter the bag does not lean, and the front face is as flat as a board.
A Matte Film over the Print, Resists Scuffs and Rubs
A matte film is pressed over the printed face, and the ink sits under it from edge to edge. The matte film does not reflect, when a lamp is above it there is no bright patch on the face. A hand on it feels a fine matte grain, it is not slippery. A nail, the edge of a shelf or anything else that rubs past touches the film and not the ink. The bright colour is held down a little by the film, it is still bright but it does not glare.
Thick Cotton Rope Punched Through and Knotted, Strong to Carry
The holes are not on the front, they are on the two sides, one on each. The thick cotton rope goes in through the hole, runs round inside the bag and comes back out, and it is knotted on the side. The knot stays outside, no rope end shows on the front face, and only one rope comes out at each side. The rope is cotton, it is thick and round, it feels soft in the hand, and holding it for a while does not cut into the fingers. With the knot on the side the load lands on the hole and the knot, and the rope does not turn in the hole. A ribbon bag puts the bow on the front face, this one moves the knot to the side and leaves the front face clean.
Logo and Multi Colour Spot Printing Are Both Customised
- Logo: screen printed, hot stamped or done in UV, set in the middle of the front or in a line along the bottom.
- Spot colours: one colour, two colours or three colours are all mixed, you give the colour number.
- Ground: white card takes a printed spot ground, or the coloured paper is ordered from the paper mill.
- Finishes: hot stamping, UV and embossing can be added on top of the matte film.
- Size: set to what you pack, the depth and the side width are changed together.
A Bag Goes from the Counter to the Customer
- A street wear shop: one T shirt or one hoodie, the bag is small and it goes out by the rope.
- A beauty store: two bottles of skincare and one sheet mask, put into one box first.
- A jewelry shop: one small square box, the bag is only a little bigger than the box.
- A festival gift: one box of biscuits and one card, it is handed over without wrapping again.
- A brand event: one bag for each person at the door, the event name printed on the front.
Rope Bags Are What the Factory Makes Often
Rope bags are what the factory makes often, and the rope, the hole and the knot each have a fixed way of being done. The hole is punched by the die, the punch is picked to the thickness of the rope, a hole too small and the rope will not go through, a hole too large and the rope shifts about in it. The crease and the fold on the mouth are done before the rope goes in, so the rope does not sit on a soft edge. The film goes on after printing and before the die cutting, the film is pressed first and the holes are punched after, so the hole edge does not lift. The knot is tied by hand, and after it is tied the two rope ears are pulled to check they come out the same length. On bags the factory has made paper bags, handled bags, gift bags and wine bags, on boxes it has made mailer boxes, handled boxes, drawer boxes, book style boxes, lid and base boxes, folding cartons, jewelry boxes and flip top gift boxes, and hot stamping, logo printing, embossing and UV are all done in the factory.